01-10-2003, 04:52 PM
|
#15
|
|
|
Quote:
Originally posted by Dr Drew
I'm assuming the amp is running two ohm stereo... Most amps are not stable at one ohm mono.
..so i'm guessing i have to get a higher wattage amp then, right?
First off move you power wire away from your RCA cables.
The 10awg wire could be part of the problem also. A few things happen when you run a lot of current through a wire that is too thin. Any time you run current through a wire an electromagnetic field is created around the wire. The more resistance of current flow the larger and stronger the field. If your RCA cables are within that field it current from the field will be transfered to the RCA cables. If you have a good set of cables (like stated above) they are double sheilded from current transfer.
|
Thanks!! |
|
|
|