|
ok, just spent two hours in my car trying to figure this mess out. When I took the cover off, one side of the bulb tested hot, and I guess the switch controls the ground, which would be the only reason why the light would not come on. I ended up taking the housing out to try to figure it out, and little plastic pieces, a spring and a ball bearing flew everywhere. I was pissed.
The pin switch works, I tested it by locking my open doors with my keyless with the switch pressed.
anyways, by the time i got finished doing that, I tested the hot side again, and it wasn't hot. I am so frustrated. I looked in my chilton's manual for some help, and it doesn't include the wiring diagram for interior lights. I checked all my fuses (since interior light is not listed) and all were good. Where does the hot line feed from? obviously I have a problem at that junction. why my light wouldn't work before I do not know, maybe the switch was a little corroded.
anyone with a better manual?
|