Ladies and Gentleman, I introduce to you BASS!!!
Anyway, I didn't have to drill a hole in the firewall. Below the battery to the right, there was a rubber "stopper" in the firewall. I just yanked it out and ran my power cable right on through. Then, I ran it with my remote turn on wire along the passenger side door under the plastic. The plastic just pops right away from the frame and you can tuck the wire right in. I ran it on along the side of the back seat and on into the trunk. As for my RCA's, I ran them under the plastic center console, up under the back seat, along the front of the back seat and then around the drivers side just like the power wires and on into the trunk. I almost didn't have enough length to reach my amp. It wouldn't have been a problem if I could have gotten the wires under the back seat somehow, but I didn't want to fool with taking the back seat out. Oh yeah, I did take out the passenger seat. It was a cinch. About 2 minutes. The hardest part of the whole thing was finding a place to ground my amp in the trunk. I looked everywhere
and couldn't find a bolt. I finally found a small hole in a bracket that was empty and bolted it up there.
Overall, I would say the job was fairly easy. The whole thing took me about 2 hours.
BASS
BASS
BASS
BASS
BASS :o BASS
BASS