View Single Post
Old 07-17-2002, 04:39 PM   #9
seanjuan
 
Posts: n/a
since you offered i'll shoot another ? at you

i'm pretty sure that once i get the screws out of the door panel all i have to do is pull and it will pop off because there are just a few tension clips holding it on then... but i hate when i'm wrong about stuff like that and don't want my door panel half falling off once i get my new speakers in

also i'm running new speaker wire into each door and wires to control my power locks from my car alarm... would you recoment taking the door off of the hinges to do this?
that is my current plan because i think i'll have to drill a whole for the speaker wire to go through (i'll use a rubber gromet and some silicon or hotglue or something to seal it once i'm done of course)

thanks again
Sean
  Reply With Quote