|
I successfully placed my foglight switch in there. What you'll need to do is take a drill with a small bit and just ream it out. What I found helpful was to take regular scotch tape and mark where the holes should be, then drill four corner holes at the intersections. After that, just follow the tape up and drill a buttload of holes in a straight line over each side.
Once you've done that, you'll have to use the drill (or an exacto knife, but be careful) to cut out the plastic under it. You'll probably need something to help you push the switch in once it's done, I used a large pair of channel-lock pliers to grab the bottom of the plastic piece from the accord (that you just cut) and the top of the switch to press the switch into the casing. That should do it.
|