Boosted3g

Well after 6 months of hard work my car is done and has taken its first voyage on the street (so what if i dont have 4-ways, turn signals, or a state inspection). Anyways i only havve about 6 miles on it so i gave it about 4 psi in 2nd and it ripped the tires loose all the way to 6k (dont want to rev it too high yet). I am damn impressed with the car and it should run hard. Heres all the work that i did on the new motor. Ill be posting some pics in the next few days.

GE sleeved 85mm o-ringed LS block 2022 cc's
balanced and polished LS crank
Crower rods
JE 9.8:1 pistons
stock Honda bearings
1mm oversized Ferrea valves
bronze valve guides
race only port job
Crower ti retainers
Crower dual valve springs
Crower 62404 cams
Skunk2 cam gears
ported Venom sheetmetal manifold
Edelbrock 65mm GRS tb
720cc RC injectors
5 gallon fuel cell
AEM fuel rail and regulator
Aeromotive A1000 fuel pump
Axexi Power FC with 3 bar conversion
SFP tubular manifold Jet Hot coated
HKS super sequential BOV
Turbonetics 42mm Racegate
Garrett 60-1 turbo
3" custom downpipe
3" Thermal exhaust
LS trans with Quaiffe diff
custom 10 point cro-moly roll cage

Ill see if i can ge the pics up by tonight. Happy boosting