JUDOANT, here's the proper way to reset an ECU..
Do this
1-When the engine is cool, disconnect negative. Leave it for 5-10 minutes..
2- Reconnect it .
3- Off all accessories.
4- Start the car, and let it warm up until the idle drops to lowest point. around 600rpm (not 6000).. If you are NOT living in very cold weather, I suggest you let it run for around 10 minutes.. Just to make sure the idle settles.
5- Then off the car.
6- You're ECU was properly reset, so you can start the car.. Everything should be fine.
Good luck!
PS. Your username is very cute..
