WELL....Look what I made.
A: Tap
B: Screwdriver extension, drilled out w/ 1/4" bit to remove a couple corners
C: Screwdriver
I "pressed" the tap into the extension and threw in some jb weld for good measure. It doesnt spin out and the slight wobble it has should be gone when the jb weld hardens. (If not, I wont be using this).
It does work. It is straight. I wish I would have thought of this sooner...
edit***WORKED! Done!
Last edited by pdiggitydogg : 07-29-2005 at 04:43 PM.
|