View Single Post
Old 03-04-2004, 10:27 PM   #20
turbowhat_n_dat
 
Posts: n/a
Quote:
Originally posted by thermalfi'd16
slowly pull the wire off. Use a deep socket. I used an adjustable wrench on mine, I think. That sensor shouldnt be too tight since you probably have not pulled it out before... it should be still torqued properly. If it starts pissin you off, get a GReddy oil filter "sandwich". Nice shit man. It has 3 holes that will allow you to later tap in for an oil pressure gauge. I'm using all 3 of them for my set-up: turbo oil feed, oil pressure, and oil temp.



Same here, same set up with the oil "sandwich"
  Reply With Quote