[thermal]

Well I started the turbo install today.... Have a few problems that I have to solve first. More stuff I had to order to include a slim radiator fan the will be a pusher (mounted on the front of the radiator instead of back). I was planning on pulling of the head off to install the blockguard and cometic head gasket but my buddy could not make it on time. I got excited so I started test fitting the turbo itself. The biggest problem is the turbo and manifold. My manifold will not flange flushed against the exhaust port because of the manifold itself seems a bit too short for a T4 compressor. The compressor is already against the block even after shaving a small area of it. I do have a solution. In order for me to make the set up fit, I will have to "sandwich" another exhaust flange in between the turbo manifold and the exhaust port. This will push the turbo assembly away from the block about 1/2 inch and have about 3/8 inch clearance. Of course I will also have to upgrade to a longer studs/bolts. I didnt wnat to take a picture until I fix the problem. It's all good tho. I already ordered the stuff I need to fix my problem. This is another week set-back which I really dont mind. i dont want to rush into this and mess up the whole set-up. I'm being patient. Pics to come soon.

In the mean time, friends are always stopping by all the time. I'm mostly doing all this by myself. Alot of people just watch but are willing to lend a hand if needed.......