HSTuners - View Single Post - Have a skunk2 camber kit? Have bad Ball Joints?

nonovurbizniz · 07-11-2003, 09:00 PM

I'm pretty sure skunk will replace those for free if you have a reciept or proof of purchase of their camber kit... I saw something about it over on h-t....

Also the bj's go bad because the boot doesn't seat properly and grit gets in there... (this is what I read)... HOWEVER... this is ususally also a problem with the ES masterkit bj boot covers... as they do not seat as well as the stockers...

there are lots of work-arounds for this though... personally my bj boots from my master kit sealed fine... but I put stuff together with an impact gun (ignoring torque specs) so it seats pretty tight.. but there are NO problems as of yet....

07-11-2003, 09:00 PM	#2
nonovurbizniz Registered User Join Date: Jul 2002 Location: ECUSA Age: 47 Posts: 2,693	I'm pretty sure skunk will replace those for free if you have a reciept or proof of purchase of their camber kit... I saw something about it over on h-t.... Also the bj's go bad because the boot doesn't seat properly and grit gets in there... (this is what I read)... HOWEVER... this is ususally also a problem with the ES masterkit bj boot covers... as they do not seat as well as the stockers... there are lots of work-arounds for this though... personally my bj boots from my master kit sealed fine... but I put stuff together with an impact gun (ignoring torque specs) so it seats pretty tight.. but there are NO problems as of yet.... __________________ I am an A$$hole... take anything I say to heart at YOUR OWN RISK...