HSTuners - View Single Post

03-23-2003, 04:08 PM

"I would NOT recomend using pressurized water of ANY kind.

Your begging for problems with that. just scrub any bad bits with a brush. you can also do this 2-3 times... it'll look brand new..

the other thing to look out for if you use somthing like gunk is DO NOT spray it on rubber parts AT ALL.. it'll degrade the plactic. even if it doesn't happen right away the gunk will peel of the protective outside of the plastic and start to dry it out.

simple green/foaming simple green don't do this. also it's bio-degradable."

-nonovurbizniz

^^^ that's why i'm confused. one will say it's ok, then the other will say it's not ok.

03-23-2003, 04:08 PM	#6
member Posts: n/a	"I would NOT recomend using pressurized water of ANY kind. Your begging for problems with that. just scrub any bad bits with a brush. you can also do this 2-3 times... it'll look brand new.. the other thing to look out for if you use somthing like gunk is DO NOT spray it on rubber parts AT ALL.. it'll degrade the plactic. even if it doesn't happen right away the gunk will peel of the protective outside of the plastic and start to dry it out. simple green/foaming simple green don't do this. also it's bio-degradable." -nonovurbizniz ^^^ that's why i'm confused. one will say it's ok, then the other will say it's not ok.