Had to delay the Dyno Tuning a bit, as I did not have a boost controller or a boost gauge. I am most likely going to throw in other stuff.
I figure i want to get dyno tuned @ 7.5lbs or so, that should give me about 13's in the 1/4 with some street slicks on a pretty lucky run.
I went out and got a Greddy 52MM boost Gauge and also the APEXi AVC-R boost controller. Once I get this stuff installed I will get it dyno tuned.
JG Engine Dynamics is suppossed to be pretty good, they have a B18 motor built up ofcourse with 22lbs of boost doing like 600+ hp.
The cost is $100 for first hour $75 after.
With what I got which isnt very tuneable it shouldnt take much. Should be about an hour. No cams to mess with and stuff like that.
|