![]() |
alarm install question
I am installing a new alarm and I don't want to put a instant ground pin switch in my trunk. There is a light that turns on when the trunk lid is opened even when the key is out. I figured it is using an instant ground switch somewhere. Is it possible to splice in to the light wire with out messing up the alarm?
|
lt green wire in the factory alarm plug
or blue/blk wire in drivers kick panel harness towards the rear |
I don't understand, are u saying it should be ok to splice in to the light wire. I want to make sure that the 12v feed to the light is not going to interfere with the alarm. also I am not sure if the wire colors are the same, this alarm is going in my wifes car, not my civic.
thanks for your reply, and putting this post in the right forum |
well first off i need to know what kinda car it is, year make model, then i needa know if the instant trigger is a negative or positive input....
|
it is a 89 mustang gt and the switch is a instant ground switch so I would have to say neg.
|
make sure you test it first, it says it's positive, it will read 12v when the door is open and 0v when closed
Code:
| ITEM | WIRE COLOR |POL| WIRE LOCATION | |
All times are GMT -5. The time now is 05:37 PM. |
Powered by vBulletin Version 3.5.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
© 2006 HSTuners.com