H22a Trubo Help NO power
 

http://www.cardomain.com/member_pages/show_image.pl?

Ok my problem i am having is that when vtec kicks in my power just takes a big fall. This is what my last dyno sheet was.



My first dyno times i ran only 169whp and 158 torqe on the top sheet.

2nd sheetyou see listed was this month 13 feb 05, and it was 200 whp and 208.99 torqe. I also question how the hell do i get more torqw than HP :confused:


My motor is completely built with 9:1 comp ratio only thing i have not after market is my cams. they are stock h22a cams

sounds to me like your fuel curves are not setup right.

my setup:

1 piece darton sleeve
je 9:1 comp psitons
crower rods
crower titanium seats
stock cams
oversize valves intake and exhuast .05mm oversize
port polished head
skunk2 adj cam gears
micropolished crank
pro billit oil pump gears
act xtream with 6 puck
blueprinted block
msd blaster 2, sci, wires

walboro intank fp
aem fuel rail
b&m fpr
450cc injectors
hondata s200 with p28 ecu

I need turbo specs. Is your Hondata dyno tuned or just base map? email me a bigger picture of your dynograph: thermal99@excite.com

hey i sent you the pics i know they arent that good. the 2nd set i sent which look better those are my first dyno runs since the install. i am running a tuned chip for hondata. its not the greatist being that we can not get it to hit vtec the right way. i am not sure what else i can do. hope those help a little.

ps the dyno on the page here is the best its gonna get. i dont have a scanner now