Gauge location opinions
 

So I have that blockoff plate where the stereo used to be, and I used to think that it'd be a good spot for my future gauges.

Now, Id rather get one of those kind that put 2 by the cluster (Id put egt and oil pressure there). Then Id put the boost over on the plate, but it'd look silly by itself.

What should I do? Any suggestions on what else I could put on the plate, if I go the new route? I feel that Id only need those 3 gauges for boost.

Just get boost and egt and put it here:

Thats what Im talking about, but I want to know what the oil pressure is also.

Maybe I could put a switch to a dual stage controller on the plate too...

i thought you were saving up for a swap pat, now you're boosting? Maybe you should forget throwing a gauge in the blockoff and do a pillar pod like i did...

Im doing both -> ls-turbo

I hate pillar pods...they just look out of place


(Im doing this thread because its so dead in here)

See if you can fit your boost gauge and a turbo timer in that block off plate, if you made the turbo timer flush mount, or close to it, that would look pretty good.

I like the gauges in the two gauges in that spot on in the picture. I don't really like them too much on the A pillar.