1994 Accord dyno?
 

Has anyone dynoed their '94 Accord? A friend has the LX trim level and would like to know what the torque curve looks like.

TIA. :)

Unfortunately, I haven't seen any 5th gen dynos floating around the board...

Care to do a dyno on your car? ;)

Heh, with the massive gains from my few mods? :D That would be embarassing.

lol. still nice to see what you got. im getting my dyno after i get my exhuast fully done.

^ like stated it'd be nice to know what you are driving around, hey if I wasn't lazy I'd get one done too

i wish i new. becuase iwas reading that a this 94 lude with 240K miles with a h23 only had 122HP. i never knew you could lose so much power buy just having high miles. with my car have 103 and some mods i like to see how much HP i got now.

Just a point of reference, I dyno'd my F23a5 (non-VTEC) Accord. With I/H/C/E, the car dyno'd at 128hp/131tq. The car has 125k miles and is driven hard, but does not burn too much oil (any car w/o cats will smoke).

I can try to scan in the sheet, if you are interested. The torque is pretty constant through the rang. At about 2500rpm the motor was making 120ft-lbs and peaked around 5000rpm. After that, the torque just dies off.

-Ducky

if you could scan it in, that would be great. i've got a '99 f23a5 with a similar setup - aem CAI, dc sports header, thermal R&D cat-back, and i should be hitting the dyno when my replacement cat gets here... i'm eager to see how it matches up to yours.