B16
 

Hey I have a question. I just got a B16a1 for my 1991 Integra. I was wondering what parts should I look up to fit this engine in my car. I dont think I can do any engine mods until I know what year and model. Should i look at 99-00 civic si or 91 integra.

you look up the mods normally for the model of the ride it came out of...As rule of thumb...:yes:

its a b series so all parts are interchangable
(minus the red-headed stepchild of the b's from the preludes)

I think the parts should fit the car and the motor. u should of got a b18c in my opinion but it's ur ride!

man the old school torqueless wonder.

i havent heard of this motor in awhile. you deffenetly need to get motor and tranny mounts to make it fit.

lets put it this way.

your motor can use the stock mounts, B=B like pdiggity said. The only thing is the tranny. i have a 1st gen b16 bottom end cause i threw a rod on my SiRII. everything else is EJ1 spec (95). Cable tranny vs hydro tranny etc. DA mounts are DA mounts and should bolt on. So if you had a b18a/b/c/d/e/f/g/h/i/j/k/l/m/n/o/p/q/r/s/t/u/v/w/x/y/z in there, youll be fine. Stock - stock.

You threw a rod???

you never saw the thread?


look at that rod...such curves

blah host took em down.

no imagestation has been running like ass the past few weeks

hey thanks for the feed back but what i was really wondering is what header and intake do I put on it. Should I get the ones for the 99-00 si or should i look at the 90-93 integra for the B16?

Si is what you wanna go by just in case.

it really depends on what chassis

if you have an integra get the intake for that

Or, a 94 Del Sol Vtec since it is OBD I. . . . . . .