Boring and stroking....
 

I've had a few questions about this....stroking is basically making the stroke longer there for increasing liters, am i right? and boring is actually making the cylander wider, am i right?

So when you want to make a car a 2.0 liter for say, better torque...do you use a healthy mix of both stroking and boring, or do ya just bore the hell out of it til its a 2 liter?

Thanks for the info guys ;)

dont do it...take it to a shop...and im pretty sure a 1.8L cannot be made into a full 2.0l (like i said in the post where you thought of this idea 1.9x is the limit...unless you want paper thin cyls)

ah ok, well with that said, what about stroking and stuff liekt hat, would you rather stroke instead of bore, or do you do both, i don't know.

I dont think its good to put a stroker on a civic engine. I think its due to the size limitations. Not to mention sleeving the block is like 10x easier and cheaper.

boring alone will get it close enough to a 2 ltr, anyone know how many liters are in a b18c???
1.797 close but not actually 1.8ltrs

my d16z6 is really a 1.590 ltr engine.

a b16 is really a 1.587 ltr engine.

didnt I say that?

edit**nope not here...musta been somewhere else...I know I did...I think Im losing it

So jsut by buying new sleeves, ic an buy them already bored to a 1.9 er whatever the number is? or do i resleeve then bring it to a machine shop for the bore?

no, you can send the to the machine shop to bore first, then to put in sleeves.

Ahh, i see...thank you...and btw, this would all be done to a b18c1...not my wimpy stock motor. hehe;)

huh? how is that since theyre boring the new sleeves?????????

Send the sleeves to the shop, and then install them after the bore....

uhh yeah thanks for just repeating someone elses wrong info, good job!

I was under the impression that they bored out the cylinder, put in the new sleeves, and rebored the sleeves to size.

Uhh, i didnt know it was bad info...hence the whole reason for this thread, thanks!

so im confused, whats the deal with this? heh:o

regardless of procedure, just send your stripped block to the machine shop, rebore/resleeve.