transmission go boom
This is what happens when the mainshaft clutch housing bearing fails catastropicly:
In other word it goes boom and you stop. |
damn..that sucks..
|
fucking ouch. What engine and tranny combo? What do you think caused the failure, and what are you going to do to fix?
|
Wow, nice little mess you have there!:eek:
|
ouchhh...have fun with that one..i hate working on trannysss:mad:
|
Well, most likley a weak mainshaft clutch housing bearing that failed catastrophily after the downshift from 3rd to 2nd to1st (I like that course) then a hard shift back into second. About 3000rpm later go boom.
I'm putting the finishing touches on the install of a new one, so the car should make it off the jackstands today. It's a ZC SOHC with the Si trans (91 EF) |
All times are GMT -5. The time now is 10:30 PM. |
Powered by vBulletin Version 3.5.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
© 2006 HSTuners.com