Msd Ignition Install Questions
 

CAN ANYONE HERE TELL ME HOW TO INSTALL A MSD 6 and the blastercoil...??? I have no clue... Any suggestoins would be much appreciated.

you dont have the instructions?

call msd and ask or email them they are very helpful...

I could sit here and tell you how to do one in general but it's better to call the manufacturer and have them send you instructions or tell you via phone/email.

you need to cut your harness from your stock coil(external) then connect the possitive and neg wires up.. if you got instructions, the wires you need are on your stock coil harness.. i dont remeber exactly, i think i might have written a how-to on it when i installed mine.

someone had told me that you had to tap into the ecu... IS this TRUE? AND ALSO HOW DOYOU RESET YOUR ECU?????

dissconnect the battery or pull the radio fuse. since you have a 95, its still obd-i, and you can reset it with ease. you have an external coil correct?

yeah i got an external coil from MSD. SO by disconnecting the Battery will reset the ECU RIGHT?

if you leave it disconneced for over a minute.... yes. you should disconnect the battery for the MSD install anyways, so it will reset its self

Coo thanks.. I think i should be able to figure it out... Did you use the anti theft deterrent thing????

im guessing thats running a wire into your car and on a toggle switch to kill the ignition? no i didnt.