keyless entry gone :(

[Aniliticalstud]

anyone know how make the keyless entry work after you take out the stock head unit. I know it's got the keyless entry sensor in it.... but it's not like i can run a power cable b/c it has those stupid clips..?

[Racing Rice]

You have to leave you stock radio in some how. Like slip it behind the console, or mount you radio somewhere else.

I mounted mine somewhere else.:yes:

[Onyx]

I just installed a alarm

[pdiggitydogg]

Yeah you gotta put power, and back-up, along with that entire set of wires from the green connector that WAS connected to the stock unit back to the radio. I put mine under the seat which meant a ton of wire and lengthening and soldering but its out of the way and my keyless works. (I just did this recently). You can get a "Y" connector for your stereo that will power the new unit and the stock. Try Crutchfield.com , you can probably get one there for like $5.

[Aniliticalstud]

tight thanks

[thermal]

go to Best Buy and get the harness. i replaced the stock radio before with an aftermarket one to keep the keyless entry. then when my aftermarket head unit face piece got stolen, i removed the head unit BUT kept the harness installed, my keyless entry still functions......just gotta have that harness.......peace:yes:

[Civicfrenzy]

I had my stock head unit pushed back and the new head unit placed in front of it :) , keyless entry works fine. I know that sounds weird with 2 units in there, but iv had no problems. Go to best buy, they can do it for you.

[2000Pimpinex]

I think instead of putting the old head unit behind the new one, it will be easier to just buy the harness. Good luck

[pdiggitydogg]

no you have to have the old unit in in order for the keyless to work. Crazy honda people.

[HondaTypeJ]

ya, place the stock radio behind the console. that is what i did.

[ArixSin]

ditto