ignition setup help [Archive]

ebpda9

01-24-2002, 05:13 PM

I wanna upgrade my ignition but i have a weird coil. it looks something like in the picture below. What module shall i get. i wanna go MSD all the way. I had in mind the 5 and 6 series ignition control module. i don't wanna spend a lot of money on it, and also i don't want to upgrade the engine further, other than I/H/E

94_AcCoRd_EX

01-24-2002, 05:30 PM

Where's the pic?

ebpda9

01-24-2002, 05:45 PM

here is the pic. it took me a while to figure it out. it had like 1mb

ebpda9

01-25-2002, 11:36 AM

anyone ?

diligent_dave

01-25-2002, 01:28 PM

MSD is some good ish. I'm gonna put some on my truck eventually...

Anyway, if I knew where the all the wires in that 4 pin connector went to I could help ya out more. But you may want to call them mofo's up and see if the MSD Sport Compact Ignition would work. Summit doesn't have it in their catalog, but Jegs does. The Jegs part # is 121-6300 or with Rev control 121-6320.

If the SCI will not work. You can throw in the MSD Stacker ignition. It just piggybacks the existing ignition and gets you more power out of it. It claims that you "connect it to your vehicle's wiring without disconnecting anything."

ebpda9

01-25-2002, 09:46 PM

thanks dave-o for this