rear strut bar.

[VR4_Craver]

No clue what im doing it should be that hard though should it? just take off the caps and bolt it on?

[pdiggitydogg]

im sure its like all the rest.
take off the panels to get to the stut tops and bolt in in place. You have to remove the strut top mounting bolts. Just undo them and bolt it on

[VR4_Craver]

yea but the panels will fit oover the bar right? And i dont know if you know but the si has that cover for in the rear to reduce glare. do you think that will fit too?

[pdiggitydogg]

I cant say im that familiar w/ the new si. Im assuming that it has panels similar to the other hatches and integras...and in them if you wanted to sport the panels again, you had to cut them.
And no, I dont know about the glare reducer.

Can you take a pic? Id like to see...

I bet it will fit as long as its a decent bar design

[VR4_Craver]

Well it done. Looks nice. Havent drove it since its been in. Easy stuff. I should make a sticky on this ;)