Bought an intake...how do I install it!!!

[GeneralDzur]

Help me guys...I looked all over the boards (and in the "do-it-yourself" section) but I have no clue how to install my new Air Intake. Can someone please post some instructions/pics?

Thanks a lot in advance

- General Dzur the noob

[4drmadness]

thanks to www.teamdelsol.com for this info.

http://www.teamdelsol.com/technical/howto/icemanIntake/default.asp

Might get a better response putting this in the tech section next time...:yes: ;)

side note that it's for an IceMan intake but the same principle applies...;)

[blind34_1]

to not be too in depth...

remove any black plastic tubing from your throttle body to whereever it ends.

fit the tubing up to the throttle body.

tighten it down.

It's pretty hard to screw it up. There are like two tubes you may have to relocate, one is a breather tube from the valve cover, and the other...i cant remember. But obviously it has to do with equalizing pressure. Don't worry about them too much.

[GeneralDzur]

Thanks. I ended up just winging it and got it installed ok. I also got some Altezza taillights installed, but they don't fit very well. Oh well...

- Dzur

[blind34_1]

altezzas not fitting well...go figure. cheap garbage, usually.