PDA

View Full Version : B16

tdubb528
02-11-2004, 08:53 PM
Hey I have a question. I just got a B16a1 for my 1991 Integra. I was wondering what parts should I look up to fit this engine in my car. I dont think I can do any engine mods until I know what year and model. Should i look at 99-00 civic si or 91 integra.
4drmadness
02-11-2004, 09:10 PM
you look up the mods normally for the model of the ride it came out of...As rule of thumb...:yes:
pdiggitydogg
02-11-2004, 09:16 PM
its a b series so all parts are interchangable
(minus the red-headed stepchild of the b's from the preludes)
MAXed Out
02-11-2004, 10:09 PM
I think the parts should fit the car and the motor. u should of got a b18c in my opinion but it's ur ride!
IALuder
02-12-2004, 12:30 PM
man the old school torqueless wonder.

i havent heard of this motor in awhile. you deffenetly need to get motor and tranny mounts to make it fit.
Shaved &/or Laid
02-12-2004, 07:21 PM
lets put it this way.

your motor can use the stock mounts, B=B like pdiggity said. The only thing is the tranny. i have a 1st gen b16 bottom end cause i threw a rod on my SiRII. everything else is EJ1 spec (95). Cable tranny vs hydro tranny etc. DA mounts are DA mounts and should bolt on. So if you had a b18a/b/c/d/e/f/g/h/i/j/k/l/m/n/o/p/q/r/s/t/u/v/w/x/y/z in there, youll be fine. Stock - stock.
nonovurbizniz
02-12-2004, 10:31 PM
You threw a rod???
pdiggitydogg
02-12-2004, 10:34 PM
you never saw the thread?
http://www.imagestation.com/picture/sraid101/p8c550a49c928494e68993658d90122f2/f9e0794f.jpg

look at that rod...such curves
Shaved &/or Laid
02-13-2004, 01:47 PM
blah host took em down.
pdiggitydogg
02-13-2004, 07:04 PM
no imagestation has been running like ass the past few weeks
tdubb528
02-14-2004, 09:23 PM
hey thanks for the feed back but what i was really wondering is what header and intake do I put on it. Should I get the ones for the 99-00 si or should i look at the 90-93 integra for the B16?
Shaved &/or Laid
02-14-2004, 09:44 PM
Si is what you wanna go by just in case.
pdiggitydogg
02-14-2004, 10:56 PM
it really depends on what chassis

if you have an integra get the intake for that
cashizslick
02-18-2004, 11:47 AM
Originally posted by Shaved &/or Laid
Si is what you wanna go by just in case.


Or, a 94 Del Sol Vtec since it is OBD I. . . . . . .