Had an accident

[honcivic97a]

:mad: I was in a accident recently where I rear ended another car. Theur car had a broken tailight while mine was in pieces. I had also removed collision on my car a week before to save money so I'm f**&#@. I can do all the work myself but I need a new radiator support, and don't know how to take off the old one and weld the new one back on. If anyone has any suggestions let me know. I am also replacing my cylinder head at the same time and was wondering how hard is it and what is involved.

Peace

[pdiggitydogg]

rad support is bolt on (98% positive)

if youre doing the same head its straight forward, but unless you know what youre doing to check timing and what-not you might as well take it somewhere

[honcivic97a]

Thanks, do you know what kind of welds its held on by, should i drill them out?

[pdiggitydogg]

edit**
my bad...yes it is welded
"yup....there are small tack welds all over..."

[honcivic97a]

I was just looking at the support theres are no bolts at all and is is welded staight onto the frame. I'm worried about how to get the thing off.

[pdiggitydogg]

reciprocating saw
air chisel
air grinder
(i did retract my previous statement)