ITR swap help

[turbodx]

What do I need to swap an Integra type R into my 92 DX hatch. I have access to Motor and tranny only, what else do I need.

[IALuder]

try to search for it under search option.

i know youll need motor and tranny mounts, shift linkage, gauges.

ben

[pdiggitydogg]

- Motor
- Tranny
- ECU
- Axles
- Shift Linkage
- Mounts
- Alternator
- Starter
- Clutch
- Flywheel
- Intake Manifold
- Exhaust Manifold
- Fuel Rail
- Injectors
- Distributor
- Engine Harness
- Sensors

did i miss anything?

[Shaved &/or Laid]

DUUR COPY PASTE OFF HMO !!!!!

lol good job Pdiggs. Cant go wrong !

[nonovurbizniz]

if it's a usdm type R you shouldn't need the harness... you just need to run wires to a couple of things...

The mod in the eg section has this swap in a cx... oh and it's "b18c5-eh2" not egwhatever I put before...

I have pm'd him... haven't gotten a responce yet though.

He has a type R swap in his cx and has used the factory harness and a chipped p28 (civic ex) ecu.

Just pm him and ask for a link to his b18c5 swap thread.

It's a VERY reliable setup...

[pdiggitydogg]

yes copy and paste...im too lazy to write all that

[turbodx]

Ok , thanks fellas. My current setup now is a B16 swap boosted and I'm using a Haltech ECU. Can I just swap in the Type R and use my current setup eg. axels,shiftlinkage,motor mounts. Also are the plugs on the motor the same as the ones on the USDM B16 , Also I know the compression ratio on the type R is about 11:1 ratio can I get away with just a head gasket to reduce the compression so I can boost it.:confused: