Have a skunk2 camber kit? Have bad Ball Joints?

[pdiggitydogg]

Well as many of you probably know, the ball joints on the skunk2 camber kit on civic's is known to go bad (sometimes after a long while, sometimes after a short while).

Well InlineFour.com now stocks replacement ball joints at fraction of the cost ($85 to $25 each).

(Now, Im not sure if its all skunk2 camber kits, or just civics...if its all cars, pass the info along, please)

Here's the direct link...
skunk2 ball joints (http://www.inlinefour.com/skuncamkitre.html)

[nonovurbizniz]

I'm pretty sure skunk will replace those for free if you have a reciept or proof of purchase of their camber kit... I saw something about it over on h-t....

Also the bj's go bad because the boot doesn't seat properly and grit gets in there... (this is what I read)... HOWEVER... this is ususally also a problem with the ES masterkit bj boot covers... as they do not seat as well as the stockers...

there are lots of work-arounds for this though... personally my bj boots from my master kit sealed fine... but I put stuff together with an impact gun (ignoring torque specs) so it seats pretty tight.. but there are NO problems as of yet....