How much ???

[ebpda9]

How much will be the install of a viper 550ESP alarm on my 92 accord ? i already took the plungeand got one for 135 brand new and i don't wanna mess with the starter install, or is it easy to do ? i know Circuit city would charge me about 600 for the alarm, relay and installation

[BrandonClaps]

since your accord is an older model you don't have the security stuff, if u had alot of time on your hands, knew how to work a DMM, Relay, and diodes. you may be able to do it yourself. here is the wiring diagram for your vehicle


| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|white |+ |ignition harness |
| STARTER|black/white |+ |ignition harness |
| IGNITION|black/yellow |+ |ignition harness |
| ACCESSORY|yellow |+ |ignition harness |
| POWER LOCK|black/white *1 |- |lower drivers kick *2 |
| POWER UNLOCK|black/red *1 |- |lower drivers kick *2 |
| PARKING LIGHTS +|red/black | |fuse box in dr. kick |
| HEADLIGHTS|blue/red or blue |- |steering column |
| DOOR TRIGGER|black/white |- |brown plug left of column |
| TRUNK/HATCH PIN|green/black |- |green plug left of column |
| HOOD PIN| | | |
|TRNK/HTCH RELEASE| | | |
| FCTRY ALARM ARM| | | |
|FCTRY ALRM DISARM| | | |
| TACHOMETER|blue | |distributor |
| BRAKE WIRE|green/white |+ |at brake switch |
| HORN TRIGGER|lt. green/blue *3 |- |column or horn relay |
| WIPERS| | | |
| LF WINDOW UP/DN|red/yel - red/blue |A |drivers door switch |
| RF WINDOW UP/DN|blu/grn - blu/yel |A |in drivers door or dkp |
| LR WINDOW UP/DN|green - grn/yel |A |in drivers door or dkp |
| RR WINDOW UP/DN|yel/grn - yellow |A |in drivers door or dkp |


Notes:
*1 The station wagon uses green/white for lock and yellow/white for unlock. These wires are found either in the drivers door harness or under the rear seat.
*2 Locate the large harness in the lower below the carpet in the drivers kick panel. Near the foot rest you will notice a piece of blue tape attached to the harness itself. Reach around to the underside of the blue tape to locate a 2 pin gray plug with the lock and unlock wires attached to the plug.
*3 High-current ground. Use a relay when interfacing with this circuit.


EIDIT: hondaman-iac tried to make the code fit in the page

[ebpda9]

thanks brandon. i guess i'll do it myself. i've been told that i need to use a relay to use the starter function, and what relay would that be ?

[BrandonClaps]

the only relay for the starter is the starter kill, i'm pretty sure the dei comes with installation instructions. you cut the starter wire in half. then u hook the key side to a certain wire and the motor side to a certain wire.